User Profile

[Andrew2]

Seems like the disinterest of proscecuting low level crime give the thieves a free run. Catching on in UK to. Facial recognition systems might help, by...

[Andrew2]

I am very impressed by the the quality of work and like the time line that gives us 'lookers' quick satisfaction rather than the real time line of...

[Andrew2]

If A C-B is using 2" tape, this will happen anyway....

[Andrew2]

I looked quite hard at Penguin, but was worried about the internal lay out and a 'little bit' about the outside 'look', so bought the Dix Cape Henry 21...

[Andrew2]

Just a thought, re: the getting the tape to go round the corners. Lay it up, then put a plastic rod each side held with little spring clamps (cothes pegs?)...

[Andrew2]

Casting is fun and looks great, but moulding in epoxy with graphite fillers is quicker and does the job. Not for the head, I just made mine out of SS,...

[Andrew2]

Can you get that battern off without too much trouble? And get carbon tape of the right width? If so, it would not take much time, despite the number...

[Andrew2]

Yes, but I doubt he will not try to influence them. He will not give up easily. It was his whole life....

[Andrew2]

On this side of the pond, a lot of problems with people claiming reperations (cash) for Britain's part in the slave trade. They tend to ignore (no surprise)...

[Andrew2]

The big question, is, Who would want the job? A dedicated politician like Biden, or, a complete psycopathe like Trmp?. Biden is not doing a bad job, but...

[Andrew2]

Quite a lot of objection to the 'polution' element of this, which is a big part of the welsh politicians argument. Cars are likely less efficient at 20mph...

[Andrew2]

Textbook, but cripes! An awfull lot of little ribs. I had forgotten quite what they were built like.

[Andrew2]

If you are concerned about ash being a different comour to CRE, won't the carbon be a bit of a smack in the eye? I envisage a bit of tutting from old...

[Andrew2]

I agree with debenriver. After my Spectra Physics laser quit suddenly, I picked up a water level from the local DIY store. Cheap as chips and I filled...

[Andrew2]

Bravo! Great effort and plenty of ideas to borrow...
A2

[Andrew2]

I understand ply is not your thing, but have you looked a Devlin's efforts? Definately the sort of boat that you have in mind. Surf Scoter could fit...

[Andrew2]

Are you sure? The equivalent boats in UK were built double diagonal with lead paint soaked canvas between the layers. All rivited. Plus, they could be...

[Andrew2]

Apparently going great guns, I saw something on the TV the other day, they are producing a lot and expect to be completely hydrogen powered in the not...

[Andrew2]

You might try looking about on this rebuild blog: Log 2015 (svnaiad.uk) The Falcon is hot moulded, but any repairs have to be cold moulded. The page...

[Andrew2]

The Wankel's demise was caused by tip seal failure. If you reved it slightly over the limit, the seals failed, very easy to do. By the time they sorted...