I need some advice on how to set up my cut list so that I can keep waste to a minimum. The lumber store I am going to get my WRC from (http://www.jackelenterprises.com/inventory2.htm ) sells it in 1" boards at various widths and lengths while the boards I will need to get out of them are 9/16" 1/2" 5/16" 1/4" and 3/16" in various lengths and widths.
I would like to set it up so that I can resaw some of the boards in such a way that one side is the right thickness for my planks while the other side is ok for say the bulkheads. For instance, could I get my 5/16" planks and my 3/16" decking material out of the same 1" boards? What combination of resaw thickness’ will get me the most from each 1" board? Anybody here good with this sort of thing, it hurts my brain a bit.