Hung the transoms on the strongback. Screwed the stem piece into the bow transom but the angle meant it didn't seat into the second mold.
I popped a couple of screws out of the supports and tilted the whole thing back maybe 3 degrees or something. Happy to live with that, really a very small change.
you can see in this image below how the after part of the support has dropped about 5mm.
sweet
Sat the base of the hull on. It sat about 5mm too far to starboard. i loosened the mold and shifted it over to suit.
Dry fit for checking. Sander is just for weight.
And glued down. Nice to see the drawing transfer is working out well. I really didn't think the plans would line up anywhere near as nicely as they are.
(you can also see the very tatty inflatable underneath that this boat will replace).
Comment