Stainless Steel Staples

[maa. melee]

Need to do some upholstery. Need SS staples that load into standard staple gun.

[maa. melee]

Need to do some upholstery. Need SS staples that load into standard staple gun.

[maa. melee]

Need to do some upholstery. Need SS staples that load into standard staple gun.

[kc8pql]

I got a box from Jamestown a few years ago.

[kc8pql]

I got a box from Jamestown a few years ago.

[kc8pql]

I got a box from Jamestown a few years ago.

[Frank Wentzel]

I've found monel staples at Home Depot.

/// Frank ///

[Frank Wentzel]

I've found monel staples at Home Depot.

/// Frank ///

[Frank Wentzel]

I've found monel staples at Home Depot.

/// Frank ///

[Matt Cohen]

http://www.jamestowndistributors.com...Rivets,Staples

In Monel and Stainless

[Matt Cohen]

http://www.jamestowndistributors.com...Rivets,Staples

In Monel and Stainless

[Matt Cohen]

http://www.jamestowndistributors.com...Rivets,Staples

In Monel and Stainless

[Bob Cleek]

The monel are far more available and every bit as good, if not better. (Harder and stiffer, I'd expect.)

[Bob Cleek]

The monel are far more available and every bit as good, if not better. (Harder and stiffer, I'd expect.)

[Bob Cleek]

The monel are far more available and every bit as good, if not better. (Harder and stiffer, I'd expect.)

[RodB]

maa,

I have some small catalogs on stainless fasteners and will post the sources later on when I get home. I think one is Anchor fasteners. I ordered stainless staples to cold mold my bottom layer of Merranti 1/4" on my skiff and left them in. I believe I have two sources for all kinds of stainless hardware/fasteners not counting Jamestown Dist...

RB

[ 10-12-2005, 09:28 PM: Message edited by: RodB ]

[RodB]

maa,

I have some small catalogs on stainless fasteners and will post the sources later on when I get home. I think one is Anchor fasteners. I ordered stainless staples to cold mold my bottom layer of Merranti 1/4" on my skiff and left them in. I believe I have two sources for all kinds of stainless hardware/fasteners not counting Jamestown Dist...

RB

[ 10-12-2005, 09:28 PM: Message edited by: RodB ]

[RodB]

maa,

I have some small catalogs on stainless fasteners and will post the sources later on when I get home. I think one is Anchor fasteners. I ordered stainless staples to cold mold my bottom layer of Merranti 1/4" on my skiff and left them in. I believe I have two sources for all kinds of stainless hardware/fasteners not counting Jamestown Dist...

RB

[ 10-12-2005, 09:28 PM: Message edited by: RodB ]