User Profile
Collapse
-
I suspect that the majority of people in that position at present have no idea what is about to happen to the line of work they are in.Or how rapidly... -
I understand the technique,but was really curious about whether you had made a template of the section to verify that both sides came out as you intended.I...Leave a comment:
-
I was about to post that the fillet looks a bit small and then I read wizbang's post.I also wonder if the mix had a bit too much filler for the amount...Leave a comment:
-
-
I'm very interested in knowing how the CNC project turned out.I totally understand that the tool trajectory will be correct,but did the blank move and...Leave a comment:
-
That might be useful if you can get somebody on a pontoon to do the observing.There is a good chance of inaccuracy if you move the occupants back to look...Leave a comment:
-
I would approach it from the same direction as spot suggests but would add a couple of points of caution.First take a look at precisely where the daggerboard...Leave a comment:
-
Interesting notion,but he'd be the new boy. If Max is still in place he might also be the number 2 on pure speed.I wouldn't be even slightly surprised...Leave a comment:
-
I wouldn't use heat,it is the normal way to break an epoxy bonded joint.If the bend really bothers you,and there is any evidence of it after trimming...Leave a comment:
-
I don't know if you may have seen it,as it seems to be a new design,but the Creizic was featured in a recent issue of Watercraft and it looks very appealing.Not...Leave a comment:
-
Quite possibly and they might have signed the wrong replacement....Leave a comment:
-
-
-
All I have to say on the topic is get hold of a really good NAS .The Seagate I was unwise enough to buy featured in a number of videos about what happens...Leave a comment:
-
The legs may have a pin or hook that engages a socket in the topsides or on the edge of the deck.Here in the UK you can buy alloy legs with a pad at the...Leave a comment:
-
There is a difference between being awarded ninety million and actually receiving it........Leave a comment:
-
-
I quite like the example that Edward posted as it keeps things low and you are less likely to snag jib sheets on the pivot pin at that height.It also...Leave a comment:
-
I'm reasonably certain that you will be able to arrive at a consistency that will work but you would do well to experiment first.Leave a comment:
-
I think you would find microballoons a better filler material than Fillite.They produce a finer textured mixture and you can adjust the consistency to...Leave a comment:
No activity results to display
Show More
Leave a comment: