Tab Content
  • PNW Crabber's Avatar
    01-11-2018, 08:55 PM
    PNW Crabber replied to a thread LYSS Build in Building / Repair
    Thanks! It's a 1977 25hp Evinrude I took off the donor boat. I kind of got hung up on this retro thing and all painted up with the decals and old...
    169 replies | 33955 view(s)
  • PNW Crabber's Avatar
    01-10-2018, 07:37 PM
    PNW Crabber replied to a thread LYSS Build in Building / Repair
    Thanks, it was a lot of fun to build. Since this photo was taken last August I have the console finished and the decals mounted on the motor cover. ...
    169 replies | 33955 view(s)
  • PNW Crabber's Avatar
    01-10-2018, 06:28 PM
    PNW Crabber replied to a thread LYSS Build in Building / Repair
    Thought I added this one - launch day!
    169 replies | 33955 view(s)
  • PNW Crabber's Avatar
    01-09-2018, 08:17 PM
    PNW Crabber replied to a thread 16 lyss #993 in Building / Repair
    I used a router that I mounted on a little sled with wedges that matched the angle between the deck and the side. With a flush trim bearing bit it...
    43 replies | 4508 view(s)
  • PNW Crabber's Avatar
    01-09-2018, 06:09 PM
    I agree on the butt block statement. Although you can see dimples in low angle light where the screws are there is no hard spot and the curve is...
    122 replies | 21982 view(s)
No More Results
About PNW Crabber

Basic Information

About PNW Crabber
Location:
Damascus, OR

Statistics


Total Posts
Total Posts
123
Posts Per Day
0.11
General Information
Last Activity
01-15-2018 11:17 AM
Join Date
01-24-2015
Referrals
0