Tab Content
  • JasonD's Avatar
    01-21-2018, 01:49 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    Oh, and the side trim was put on because of a cosmetic issue (aka mistake!), proving the old adage “it’s not the mistakes you make, but how well you...
    506 replies | 141161 view(s)
  • JasonD's Avatar
    01-21-2018, 01:44 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    Thanks! The wood here (and all the mahogany-shade wood on my boat) is sapele. I have a plank that has pommele grain when ripped. From the wood DB,...
    506 replies | 141161 view(s)
  • JasonD's Avatar
    01-21-2018, 12:24 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    Sometime creative clamping solutions are needed in boat building: Untitled by Jason D, on Flickr
    506 replies | 141161 view(s)
  • JasonD's Avatar
    01-20-2018, 01:58 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    It seemed like a good day to varnish! Untitled by Jason D, on Flickr The varnish is Epiphanes high gloss, thinned 50% for the first coat. ...
    506 replies | 141161 view(s)
  • JasonD's Avatar
    01-19-2018, 07:44 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    Thanks! I appreciate you following along and commenting.
    506 replies | 141161 view(s)
  • JasonD's Avatar
    01-19-2018, 05:05 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    Next up are the rub rails, made from sapele. The same stock that the coamings came from provided the starting point. 12mm x 28 mm, with a bit of...
    506 replies | 141161 view(s)
  • JasonD's Avatar
    01-12-2018, 05:47 PM
    JasonD replied to a thread Harry Bryan Betty in Building / Repair
    Beautiful, just beautiful....I love it.
    995 replies | 240748 view(s)
  • JasonD's Avatar
    01-12-2018, 04:23 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    The rear deck was considerably easier, and I cut each piece to fit - far less bending into curves back there. Untitled by Jason D, on Flickr ...
    506 replies | 141161 view(s)
  • JasonD's Avatar
    01-12-2018, 03:54 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    First, I used a washer to draw a straight line with consistent spacing that matched the other caulking joints. Untitled by Jason D, on Flickr ...
    506 replies | 141161 view(s)
  • JasonD's Avatar
    01-12-2018, 03:41 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    Almost done with the deck! Today's work was to fit the king plank into the deck. For the fir strips: I did not trust my ability to cut all the...
    506 replies | 141161 view(s)
  • JasonD's Avatar
    12-29-2017, 05:54 PM
    JasonD replied to a thread Florida Beg-Meil in Building / Repair
    Grabbing scraps of time where I can, I am making slow progress to finish the deck. To finish the starboard side by the coaming, I made a little...
    506 replies | 141161 view(s)
No More Results
About JasonD

Basic Information

About JasonD
Location:
Sunny Florida
Tell us:
e

Statistics


Total Posts
Total Posts
471
Posts Per Day
0.29
General Information
Last Activity
01-21-2018 02:09 PM
Join Date
08-26-2013
Referrals
0