Tab Content
  • Quest's Avatar
    02-21-2018, 10:15 PM
    I did the same on the stb side: Below is a before shot looking from aft (also note the floppy ceramic disk on the grinder to the left): ...
    619 replies | 204323 view(s)
  • Quest's Avatar
    02-21-2018, 10:07 PM
    I'm continuing on, slowly getting my groove back. I've cut the hole in the bowsprit to allow it to sit over the stem fitting. Note the angle...
    619 replies | 204323 view(s)
  • Quest's Avatar
    02-14-2018, 04:50 PM
    And Rick, I'd be keen to see how your berth arrangement I saw you talking about comes together so I can shamelessly steal ideas. Photos!!! Mal
    619 replies | 204323 view(s)
  • Quest's Avatar
    02-14-2018, 04:45 PM
    It's good to be back, yes Larks working away is done. I don't have to tell you how much it sucks! Andrew hope you are better, I've been stalking...
    619 replies | 204323 view(s)
  • Quest's Avatar
    02-13-2018, 08:23 PM
    While I was on a roll I took the inside of the stem back so I could slide the stem fitting in place: Time to get this thing done!
    619 replies | 204323 view(s)
  • Quest's Avatar
    02-13-2018, 08:22 PM
    I'm back. Boat fund topped up, rubbish out of the shed, spiders driven away and motivation off the scale. Starting small to get back into it,...
    619 replies | 204323 view(s)
No More Results

Statistics


Total Posts
Total Posts
502
Posts Per Day
0.21
General Information
Last Activity
02-21-2018 10:18 PM
Join Date
08-08-2011
Referrals
0
Home Page
http://sundownerbuild.blogspot.com.au/