View Full Version : Tiller head fitting source.

Dale H
08-13-2001, 10:13 AM
Does anyone know of a source for a bronze tiller head fitting for a 1 inch shaft? I've found a few on the web but some of the prices are a tad steep. TIA


08-13-2001, 04:46 PM
Try Edson Corp. in Mass. They have them listed in their catalog and probably have a web site.

Wilson Fitt
08-14-2001, 09:52 AM
Also try Bristol Bronze. I used one of theirs but ended up modifying it substantially. Might have been easier in the end to make a pattern and ahve it cast.