View Full Version : leaking deck plates
geronimo74
05-16-2009, 12:17 AM
I have installed 2 deck circular deck plates so I could keep check for leaks and now the only leaks I have are ,when heavy rainscan't drain fast enough and I get small buildup on deck(1/4 inch) water seeps in thrue the lid seam,,I was thinking that I could seal them with a goop that dosn't set up or get hard ,,petrolium jelly ,bearing grease any other Ideas,,,this is not a luxury ride just a down and dirty fishing boat
Todd Bradshaw
05-16-2009, 12:55 AM
It does, however, contain that dreaded word "silicone", which is often a royal pain in the butt around anything that occasionally needs to be repainted or revarnished. I might be tempted to try the petroleum jelly, or maybe even a bead of plumber's putty before reaching for anything containing silicone.
David G
05-16-2009, 01:18 AM
I've sealed deck plates with 3M 4200, and with Dolphinite. Both work quite well to seal. The Dolphinite is much easier to take apart.
"The more you find out about the world, the more opportunities there are to laugh at it" -- Bill Nye, The Science Guy
Just a thought - seems like bad design so check that there isn't space for missing o-rings. Rick
bloggs68
05-16-2009, 02:47 AM
They always seem to leak no matter what you do.
Could try these
http://www.armstrongnautical.com/dckplates.htm
AD
geronimo74
05-16-2009, 10:03 AM
The leak is in the cover not the flange and I do want to be able check below decks and I do open them up for ventilation on the hot daysI will be trying a few things so i'll post the results I used to use ahight tech sealant gelly on glass neon vacume manifolds sorta like grease
David G
05-16-2009, 11:33 AM
They always seem to leak no matter what you do.
Could try these
http://www.armstrongnautical.com/dckplates.htm
AD
Interesting. I've never had one leak. I wonder why the disparity. Do other people have the same experience?
ABfish
05-17-2009, 08:26 PM
Try some plumber's pipe dope, or thread sealant, with Teflon. It's thicker than petroleum jelly.
There are the snap-in types, and the screw-in. My impression is that the screw-ins are much better if you're going to be taking them out frequently.
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.