PDA

View Full Version : Bending Teak



Bruce Ebling
06-26-2005, 11:20 PM
I have a 10" X 8' long teak board that is 3/4" thick. I need to fasten it to the sides of my Cape Dory cockpit. The board needs about a 2" bend in the middle. That is too much to ask of the screws that hold the board in place. Is there a way to introduce the bend into the board?? Any suggestions would be greatly appreciated.
Bruce Ebling

ssor
06-27-2005, 05:49 AM
Support it on the ends and load it with what ever is at hand until it has the bend you want, keep it wet for a few days, unload it and see how it looks. A two inch bend in ten feet isn't much.