View Full Version : Building / Repair
- Antifreeze in the bilge.
- Rool & Tip. Why Brush?
- wood available from estate of Ellis Rowe
- flattening agents
- Mill Creek 13 Kayak
- Compass Rose Corners
- Mini Bristol Channel Cutter
- Lyle C. Hess Boats
- Newbie gunning dory renovation
- Help me pick a color
- Grey Seals Deck
- What kind of wood is this
- installing drain plugs
- mahogany dinghy restoration
- removable cabin
- Shoal Keel of HR-28 on Trailer for sale
- What glue for bungs below waterline?
- Old Bartender
- Rushton pulling boat
- Killing Mildew?
- Laminated plywood stem
- Another 19' Bartender question
- Brand new baby in a brand new cradle boat
- Converting a dry exhaust to wet.
- Another dumb question.
- A handy shop protractor
- Eilean being restored
- Making Block Shells
- "Lady Elizabeth" Designed and Built by Lyle C. Hess, need's some help!
- New build--Simmons Sea Skiff 18
- In appreciation of work properly done.
- A job I was dreading
- 55 chris craft ceiling boards
- Cabin side lamination
- All wired up 12' Sassafras canoe
- Best time and method to expoy glass in?
- Splash - SOF kayak
- Hollow 13.9 foot surfboard
- five sided tenon - help!
- The new Doggie dinghy works great!
- Mast storage
- A "Rotten" Day...
- teleflex steering
- VIKA-19' Sharpie progress
- Estimating Building Costs Using Traditional Methods
- Red lead coverage ?
- Have you guys seen this? Linseed Oil Varnish.
- Splintered oar crisis
- The Turning
- Dumb question
- Mill Creek Kayak
- Lug sail help
- repair Question
- Thermocontacts specified for 50ºC/122ºF
- How do you Remove Old Paint from Canvas
- Dolfinite
- wire stays
- polysulphide bedding compound
- Want to build a wooden party barge..
- Exhaust question
- Ok to use different brands of epoxy on same project?
- Self Bailers
- green boatbuilding
- Floor seams
- Sanitred for Oh Joy?
- Baidarka finished, with pics
- Shrinking the new canvas
- Brass/Copper Interaction?
- Wood boring bugs in my new cedar
- Lapstrake Planking
- Steaming Oak Question
- Outboard mounting plate
- OSS oars in the building/plytard build here.
- Chrysler Crown oil presser
- Skin on Frame Boats (discussion)
- Ecothermic Epoxy Heat
- Leveling fore and aft with rocker
- How can I remove epoxy based paint?
- 'Epoxy' woes
- Progress on "Vapor"
- Progress on the Canoe
- before I put her in the water...
- Success at the boat shop
- H28 sloop spreaders and jumpers
- Help with refitting my propellor shaft
- Burnout
- international 110, should I take it?
- Oar Leathers
- Renegade "Help me find her"
- neat build story from CNN
- Glen L 14 more progress....
- Sagging Hog
- Tiller extension connection
- Bending Ash?
- Splining seams on mast
- Designing a small head
- Glued seam ohlson 36
- will epoxy stick to pvc pipe?
- How many BTU heater for a 30 footer ?
- Getting gasoline out of tank
- Covering Fender with Hitching Questions
- Attaching Reef Comb to Boom - Questions
- Nicks, cuts and scrapes on hose clamps
- Cedar planking
- Boat ID
- OK Dinghy needs work
- Johnson outboard mechanic in Atlanta
- Boshield
- Product Help for Hatch and Seats !!
- Minimum stem thickness
- And the refit continues...
- ARAPAHO's Båteka, the building of
- keel hung rudder shimmy
- Cold Molded Hull Repair
- Mast Hoops What Finish, if Any?
- Heard of Lesonal 94?
- Mainsheet system
- Are these salvageable?
- How often to recaulk a wooden boat
- Mast compression
- Launching Day For Evan Williams
- Black Spots
- Sam Devlin
- Fiberglassing Question
- fuel tank placment
- Varnishing in direct sun?
- Building an Eastport Pram question
- Penguin '68 - nail heads question
- Propane to keep paint from skinning
- Looking for guidance
- some decky type questions
- Looking for my next project
- Need ideas for furling line tensioner
- Bending in Frames - A Lucky Break
- Epoxy and screw question
- Monk 1948 Restoration
- Pendragon's refit
- Installing New Winches
- Lightning floor boards.
- 110 follow-up post
- Wood plugs set in varnish
- Dryed Out Hull
- Perfect weather
- Birch Canoe Build
- Grey Marine Fireball V8 Carburetor Rebuild
- Shellback breast hook
- lobsterboat riding sail rig?
- Composite Panels
- Ostkust Winch handles?
- Timing a Chrysler 15hp outboard
- Main halyard - brainstorm / advice
- Prop options
- Which Milwaukee drill?
- pine sap and epoxy
- Outboard Control Cable Hardware
- Forestay Tension
- A not so nice refit surprise...
- Scantlings for Bearding to Apex Distance
- Cutting long skinny tapers
- vacuum bagging
- Grey Seal rollover
- Ipe as a deck material
- Potential Newbie Restoration Project
- fiberglassing problems
- Inspect those hoses!
- Appreciate advise on building tongue and groove deckhouse
- Transom Saver
- Wheel to tiller setup - how to?
- filler options for checks (or) elm frames
- Dory Planking - Upside Down or Rightside Up?
- Original Dufrene Cruiser
- dodgy knees!
- Small Wittholz Catboats
- Mystery build/resto' in Victorian hills
- Sea Bright Skiff & Sail Rigging- (New To Forum)
- Testing cured paint for oil-base vs. latex
- Stephens Bros. of Stockton CA
- steaming mahogany question....
- Little Jim relaunched..
- Newbie Glass Cloth Questions
- A bit of help here
- kirby paint on epoxy with glass
- Ringnails or Dowels for strip-planking
- Surveyor needed
- Finally Finished (Sort Of)
- Red Lead on Doug Fir Deckboards
- Twin Disc "Crash Box" parts
- Feckin Notches
- Cleaning the fuel Tank
- A Stamp for the Peter Sibley Foundry
- Skin Built?
- Blue Jay 492 rides again
- Joint type for bottom planks of a sailing dory
- Ply-A-Lume Restoration
- Rangeley Lakes Boat Build
- bedding compond for new mast
- A brief question regarding 'roll and tip'
- Cedar Strip Repair Question
- before the days of snaps and twist lock fasteners?
- transom height
- rope/wood Swim Ladders
- Dinghy foredeck planking options - any photos please?
- Seized 2004 Tohatsu Outboard
- How will it float?
- Painting article in WB 207
- VARNOL thinners
- Outboard Motor for Haven 12-1/2
- Boat trailer wiring (grounding?)
- Paint thinner question (answer tonight?)
- Hatches and Butterfly hatch thread
- Tanner Boat Works, Chicago
- What to use to cut stainless screws?
- What kind of window bedding?
- Flotation Foam Compartment?
- Varnish over epoxy
- Cockpit refit on a 1947 Wianno Senior
- To zinc or not to zinc?
- sistering ribs Help!
- Varnishing Strategy
- Oh Joy repair question
- 12 Foot stitch and glue flat skiff help
- More Oh Joy goodies.
- Any solutions?
- Building a Beach Pea II
- Bedding or not
- Removing Sikkens Cetol
- restoring aluminum trim
- 1948 Roof suprises - Help me out, pls
- Freshening up varnish
- Moving 36' Garden without mast
- PL Premium in the fridge??
- thou shalt not covet
- Herreshoff Halyard Snatch Block
- Repairing small cuts in canvas decks
- New Build
- Canvas decking
- Removing epoxy from polyethylene tubs
- galley cabinets
- Black stains on varnished rubrails - help
- removing latex paint?
- Which paint for bare wood bottom
- Does anyone clean paintbrushes anymore?
- Rotten Mirror dinghy hull - advise please?!
- You are never out of work with wood
- 50' wooden cruiser
- Hot coating paint and varnish?
- wiring for diesel starter, alternator, and external regulator
- Greenwich Diesels
- Hours to build shellback dinghy from kit
- Spartan outboard bracket mount installation
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.