View Full Version : Building / Repair
- epoxy "potting" fastenings
- Paint question
- Fogo Island Regatta
- Its Pointless
- Moisture in the chain/line locker?
- Treatment of wood on deck.
- Proper washdown routine for wooden boats?
- Pressure washing off the piant??
- Rot prevention/Wooden Boat Maintenance
- better way to cut lap gains?
- Loading dinghy in truck
- Rubbing out 2 pt polly
- Drawer Sliders Help
- Herzel birdsmouth oar article?
- My First Garage
- plywood dory caulking, filling techniques
- lapstrake W.L.
- Optimun paddle length?
- Strip planking wood/size
- What cloth weight for the 10' canoe?
- un-perfection
- Proper STAIINS, Vintage C.Craft with CPES
- gold leaf lettering with a mask
- tallowing shaft logs
- filling between poor fitting planks?
- Linseed oil turning black....
- Electric Conversion
- 19 ft. Sailboat photo update July 2008 #3
- The Ideal Shed Thread
- Chopstick boat
- Help with Moulded plywood repair
- Oid Saw refurb - advice please.
- Epoxy sanding questions
- oiling the interior of a wooden boat
- Building Boats with Kids
- Bottom Paint
- Fairing compound
- Μοναξιά floats at last!
- single handed mast raising rig question
- Plywood transom delaminating
- Tanton yacht l'ill rooster tug boat
- Introduction and advice
- Launched Olallie this weekend! w/pics (duh) :D
- A large electric boat cruise without oil for ever
- Pointlessly floating around
- Another New Guy
- Varished Floorboards? Please Help
- Confused: completing stems on S&G Rob Roy
- Registering backyard built boats
- Trailer security
- Help with prime coat. Bare Hull
- what to paint the dory with?
- Exterior varnish finish
- paint system for galvanised mast bands
- Bronze Winches
- Electrolytic cleaning of steel?
- Optimist Pram Restoration
- mirror dinghy restoration
- Boats out of the water
- What would you make with this wood ?
- Trailor light question.
- CPES versus WEST
- My new boat
- How to make bronze bolts lie flush against chainplates
- Gas to Electric Conversion ready to launch
- Bottom paint over RAKA epoxy,
- Weatherly? Oh Sharon...
- Modern repair on traditional boat
- salvaging x-ray lead
- How do I tar rope
- Help needed with a "free" boat in Seattle
- Aluminum Restoration
- oar length for skiff?
- new sail diagram for the green boat.
- Dowels or Spline?
- 1928 - Rumrunner
- A tale of two mainsails
- Atkins shoreliner stability.
- Help needed identifying boat
- Cutting angle iron
- epoxy 1 Pint
- Paint question
- ideas on really reputable boat plan companys
- Sail plan balance help
- New Splash
- Mooring chain corrosion problem
- Plywood hull water stains- please help
- Fifie Stern arrangement
- Finished Painting a Wineglass Wherry
- Corrogated cardboard boat races
- constructive (please) criticism on a diff. proj.
- Workbench for boat building
- Fastening for Lumberyard Skiff
- Pathfinder Launched
- How to seal the Centreboard pin?
- unlaying rope
- boat bike trailer
- Corrosion issues on shaft log
- Atkins - Topsy
- Oval bronze port hole
- Blue Moon _Turkey
- Adding a bilge keel
- Spoon or flat blade oars?
- Strip cutting
- Shipwright Needed
- Photos of Hull re-construction & question
- Baby Tender II -- promised pictures
- Steaming Oregon
- flotation chamber
- Water borne stains on oak
- Wheel Steering Best Methods & Reduction Ratio
- Repair or Let go
- Installing vertical surface veneer
- Brockway skiff in Florida
- laminated cedar stem on whitehall?
- Anybody know Weller soldering guns?
- Stripping paint?
- Update on S/V Laura Ellen
- Rain on Uncured Epoxy
- Painting
- Oh Howard...
- Electronic ignition for a Chrysler Crown
- Melonseed - Paint and Varnish Complete!
- "real" wood transom on ply skiff ?
- How dry is dry when it comes to varnish?
- An "Eun Mara" is born...
- oar storage in boat, need ideas (pics)
- Cutter half hull
- A Center board in progress
- Tom Cat being built by Gregg H
- Alleged Am.Cup Yacht's tender, Pocahontas?
- Welded polyethylene tanks
- question re: AC Exterior vs AC plywood
- Yanmar YSE12 Diesel
- save a classic in seattle?
- hard mount or rubber mount?
- Strip Plank construction.
- The Finish?
- Interlux prefection
- Mast Gate
- Sapele BS-1088 Woes, is it dyed?
- Sam Devlin vs. John Welsford
- oarlock questions
- Sealing Plywood Sailboat
- Mahagony restoration
- Mahagony restoration
- Shady Lady update
- Coating polished bronze
- Oslojolle
- Epoxy over paint
- Ratlines
- Planking for NZ Pilot cutter
- Wax removal
- Wax or oil my bronze pieces?
- cheapest pocket cruiser?
- Sealing around centerboard opening
- Sheating of an old wooden hull in ferro-cement?
- Sealing around centerboard opening
- building a small sailboat
- Polyurethane glue
- How to mate stem piece (curve matching)?
- Question: Drilling a Centerboard pivot?
- Thompson dinghy
- nick deltorto
- my apologies to all I offended
- Oak for steam bent frames
- Transoms
- horsepower calculator?
- Formal introductions, 26' Calkins Bartender
- Bay Skiff 15 Update
- Replacing Mast Hardware
- 50s boat plans
- Long Time Lurker/ First Time Poster Needs Opinion
- Effect of oil finish on epoxy
- Best Wood Sealer
- What was the first boat you built?
- Big Drip
- Plywood Hull Repair
- Another Free H28 in SF Bay area.
- Ideas for easily removable tiller/rudder connection
- Aluminum to Plywood
- Transom goes on this weekend
- diesel / epoxy
- 16ft clinker/lapstrake restoration
- Chafe guard for raw water hose thru bulkhead
- Cockpit drain hose choice materials?
- retaining the boats shape
- Lumberyard Skiff missing lenght
- Worm Board
- Birdsmouth Mast
- Installing Cedar Ceiling?
- Oarlock Socket Mounting: Wood Screw or Machine Screw?
- anyone with any hints on how to get rocker on a skiff?
- wooden mahagony lapstrake
- How to Unbuild a boat
- mainestream
- Melonseed Launch Day!
- wood lapstrake- wingman
- BEWARE Neglect!
- REAL Chemical Stripping, NOT SCRAPING
- to prepare for a Maine Winter
- Rounding Over or Not?
- 1/2" rub rail
- Why Enclose Cuddy Cabin?
- Does fiberglass offer the most STRUCTURAL strength on the inside or outside?
- Finishing mahogany planking
- Weatherly's Launch
- rank beginner question
- Shop-made outboard tiller extensions?
- Trading boat for baby
- Toredo
- Cedar planks
- Ngatira restoration progress
- Well, Oh Joy is finally feet dry.
- Building Beth - first pics
- What To Expect?
- What kind of mahogany?
- glass in deck "butterfly" hatches
- problem oil lamp
- ZEPHYRUS Sailing
- Steel Over Wooden Hull Questions
- Grey Seal Painted Grey
- Thanks guys. Bad explosion. Keep us in your thoughts and prayers.
- FREE Penobscot 14 station frames!
- re-scribing lapstrake waterline
- s&s dark harbor 20 first build
- Cold Molding question
- folkboat caulking
- Restore Vs. Rebuild
- Dark Harbor 17 photo's
- Moon Shadow
- Depth Transducer
- Lumberyard Skiff Stem and Tensions
- Wooden Boat Maintenance Costs?
- Xynole or fiberglass cloth
- Home made bedding compound?
- Haven 12-1/2 question
- Peapod on the east side of atlantic
- Hatch rebuild
- New member with foam core question
- Nutshell Launch
- folkboat decking
- Folkboat Repair
- Cell Phones and Cruising: Does Anyone Know?
- interior paint
- Best finish for pine deck
- Dark Harbor 12 1/2, 15 and 17
- Keeping the rain out during repair
- Building Beth - cont'd
- Use of a heat gun
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.