View Full Version : Building / Repair
- Old Seagull for an outboard?
- scarf strength?
- air dried vs. kiln dried b. locust
- constripated tablesaw
- Scottish ketch Violet
- Sail Trim
- Teak plywood for deck versus teak veneer???
- What's your building site like?
- Sail Trim Too (Two!!)
- Greenland Paddle #2
- Riveted blocks inside clinker hull?
- Tell me about paddles
- silicon bronze screws
- Fixing butt blocked planks
- misaligned centerboard slot
- Wht oak lamination in progress
- One Person Carvel Planking Tips using Copper Rivets and Roves
- Seabird Yawl
- water pump drip
- Rubber paint
- Tabernacle for flat fish
- Repower - Motor Mounts
- Tips on Riveting Carvel Planks with only one person with pictures
- Mahogany and chrome
- Walt Simmons fastening kits...
- Status Check - 21 September 03
- Species Dillema
- 80' Gloucester dory??
- Can You Pass The Test
- Boat wont plane / Velvet Drive Rebuild??
- Moving pictures
- More on scarfing
- remove 3M 5200
- Weekender Bowsprit
- Fastening stays to spreader?
- Search repair forum
- rascal progress 9-22-03
- Hull scraping 101 questions
- LEAD BALLAST
- Accent Stripes
- seperated garboards
- seperated garboards
- White Oak & Laminating
- Getting started questions
- Varnishing Gunwales
- Handle for roller reefing main
- sharp chines
- cedar strip sailing dinghy restortation
- SEA URCHIN
- wet exhust
- Seal Underside of Deck ?
- steaming science 101
- "Old" Epoxy
- Quickie floozie update pic
- Redwing 21 Pilothouse
- power spray her guts
- TALLY HO II update
- Wisp gets wet
- How do ya match existing nonskid when replacing part of deck?
- Coyote II design - what do I do with all that shaft?
- Soon to be, do-ree, pics!
- Restoration project 29'4” x 22'6”wl X 6'6” X 5'2” Plank on ed
- Building a Tom Blake "Kook Box"
- Someone has to want this thing...
- Started to Build
- determining ballast req's
- Laminating with dry clear red oak
- Copper in the transom?
- Distinquishing polyester from epoxy coating
- Suggestions Wanted: Supporting a 72foot Wooden Boat on Land
- Can I save my transom?
- Penobscot 14 half planked - free to good home
- Help! My clench nailing is a mess!
- Scheherazade is launched. Where are photos?
- Pre-soaking
- Fiberglassing over carvel planks
- Garber/First plank replacement Lapstrake
- re: buying 1964 Cheoy Lee Robb 35
- Opinions needed! ...Engine dilema.... should I "re-load"?
- Progress photos - windshield installed
- Oughtred's ACORN dinghy
- Decked canoe weight poll
- Running backstays
- alden ketch, the start of the restoration
- Gold Plate
- PLANK REPAIRS
- Boot stripe width - 20' Chris Craft Holiday 1962
- Hemp
- progress pics-kingfisher pram
- Determining lumber requirements
- Launched "Bill the Cat" Today
- CPES help
- Teak and Oil
- One final "progress update" for the Dark Harbor...
- 3M 5200 vs. 3M4200 for bottom seams
- Free Oak???
- whattodo?glue?
- sikaflex
- Sprit rig, topsail ? for Todd B.
- Restoring a Vertue
- Help to decide to buy?
- Swamp Witch update
- preparing for varnish
- One step forward, one step back
- chain plates
- Pete's Barn, take two - pictures, pictures
- Canvas Canoe
- Marine Plywood
- Boatbuilding Schools
- Poplar for hardwood applications
- impregnating wood protector
- CPES a Centerboard?
- Gudgeons and Pintles
- Thwart, benches, and their supports
- Looking for recommendation on gages
- V-shaped skilsaw blades
- Brushable Awlgrip
- Thumper and Cleat
- Hardtop repair
- Oars for my dory
- Restoration of 16' Cruisers Inc.
- lapstrake - plywood waste
- photos
- Elisabeth Grace has landed...
- Bedding for window
- Small leak
- Lapstrake Interior Refinishing
- Putty for Marine Use
- Sneakbox refurbish
- Cold Molded Schooner & Water Infiltration
- Caulking literature
- Boathouse Plans
- Best epoxy for cloth layup on new ply
- House Boat Plans
- seat caning material
- Eun na mara (duck flat)pics??
- kingfisher pram-pics
- Appologies, appologies, but Coriolis sails again!
- Fiberglass resin removal
- old metal ?
- Urgent Help..is my Marine Ply OK...
- Epoxy suitable for fuel tanks....
- What Grade and Cut White Oak For Keel
- doorskin laminations
- Varnish/oil or bare wood.
- Whats your prefered plywood hatch method?
- brushes vs. spraying
- 4-fold rule questions...
- Traditional Treatment
- iron floors
- clinker restoration
- Fillets wood, yum?
- Inboard motor update ??s
- Swim platform
- stands
- Primer/sealer for above-waterline timbers?
- Centerboard Pin
- Building a Cuttyhunk windscreen
- Eyeglasses in the shop
- gel coat on new construction
- Availability of Canvas Sailcloth?
- mirror images
- below the waterline
- Mackenzie Cuttyhunk- What do I do?
- Best choice for steam bending
- Alder wood
- Sealing checks in a wooden pole mast
- scantlings for a boom
- torn canvas on cabin top
- moveable internal lead ballast
- Resealing Lapstrate Bottom at Transom
- Removing Black stains on Plywood Next to Ribs
- Old Propane Bottle for steam bending?
- Anyone building a Penobscot 14
- More help with steam bending??
- Making mast hoops
- Free FG. sail boat (pic)
- Taylors kerosene stove VS propane ?
- Fixing keel dry rot in Thompson boat
- MAST HOOPS
- Info on '1969 Stevens ketch'
- Teak Stained?
- Twisted hull?
- Joggle sticks
- Wood -Apitong
- Painting Varnished wood
- Strip Kayak
- Iorangi .52ft Logan 1901 is launched
- Centerboard Leak
- Building Navigators - Oct 20 Status
- Removing interior paint
- varnish on bottom ??
- New website on the construction of two 'Sweet Peas'
- plywood skiff deck
- Repair Cracked Ribs?
- Fix cracked wood ?????
- Schooner Roseway...restoration in State of Maine, USA
- Chestnut for boat parts ?(pic)
- Water stains on oak
- Inboard motor - rotation change?
- Propeller sizing
- This is all over my head...
- New Project (WOW the air is thin up here ) :)
- CB Pin Solution
- Leaking Lapstrake
- enamel vs poly
- To: Jim Budde
- Oak flooring for decks ?
- Lapstrike Construction Books
- Hardwood/Resocrinol
- 3M Scotch Brite paint remover
- White Pine at the Big Orange place
- Re-mounting a snapped mast?
- Strip Planking a Hull
- galley counter material
- Teak Sawdust as epoxy filler?
- Floozie not topless pic’s
- Total Newbi Question
- nutshell pram
- Building Navigators - Oct. 26 Update
- Corrosion examples
- How to finish my lapstrake canoe?
- Toe Rail Finish Question
- New boat a-buildin...
- need advice-H-28
- Pump Leak
- Rivets
- The Cheap Pages, note on URL change
- Paint question
- carter carb for 61 Chris Craft
- bulletproof sole
- fiberglass to old wooden boat
- Kirby Paint/ Cpes
- Modern Sail Furling Systems
- Canoe seats
- Hull Assembly Methods/Plans Site
- EUN MARA...builders.
- The five year plan
- Good wood boat info
- Wood for Strip Planking
- Lap Strake Nuts, CC Skiffs
- Check my repair schedule
- one week to splash
- Help - Stop me before I restore again (Winthrop Warner)
- Has anyone built Oughtred's John Dory?
- goop ,gak , compound
- Halfhull mounting
- Kayak....DIY WEBSITE
- Lyptus
- sound suppresion
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.