View Full Version : Building / Repair
- Wood screws
- varnish over epoxy
- Planer Scarf Jigs
- to boot or not to boot?
- A different kind of a launching...
- Gluing Transom
- What holds up against beer better?
- 1st time canoe Help!
- Seam filler recipe
- Now the real work starts
- Mahogany hull in freshwater
- looking for the best plywood available.
- Iron Keel Bolt Replacement
- July 2001 Gone Sailing
- Pulling the Head
- Chemicals from Wood
- How do I post photos?
- CPES-a modest proposal
- White Oak
- Shellback Kit
- Fire Hazard: Recall on Dewalt/B+D Battery Chargers
- Stem Question
- fiberglass battens
- Buzzards Bay 14
- Bosch Random Orbital failure. Designed in?
- Status Check on Folkboat
- Time and Materials
- Keel material
- I Need Jigsaw recomendations.
- Chain Saw Recomendations Please
- Chain Saw Recomendations Please
- carved side boards
- Outboard mounting on a double-ender.
- gooey deck seams
- Gummy sandpaper
- More gooey, gummy stuff
- Penn Yan problem areas?
- Star Ten
- Hull plank gap
- to cold mold or not to cold mold
- 1st time canoe advice
- Rebuilding 30 Footer
- Rock hard water putty
- black stain on oregon
- Status Check - 19 Aug '01
- catspaw dinghy
- bloke looking for blocks
- bow shed
- Wooden trailer for a Wooden boat?
- Almost ready to launch.
- old International 14
- Planking the Haven
- (semi-) composit construction
- Need Restoration advice...
- Old boat
- Plank to frame joint: fasten from the inside?
- can I use SPRUCE for frames?
- Fastenings with an iron keel
- 15' Whitehall
- Boot stripe
- Zinc
- How long can I stay hauled out for?
- Safety Standards for Backyard Builders
- Engine Room Air help?
- cpes yes or no?
- Sherwin-Williams Tileclad Epoxy paint
- Okoume and Meranti Plywood vs Fir Plywood
- Loose Glass
- White pine vs cedar in strip building
- Skipjack haulout
- Galvanized spliced wire shrouds
- Gaff sail trim on Haven 12 1/2 , etc.
- I can see! I can see...
- Replacement for lead lined shaft alleys
- I'm coming unglued!
- Stem replacement
- VROOOMMM VROOOMMM
- to strip plank or not?
- Sea Bird Yawl (and Zinc)
- Sikaflex
- epoxy stains under varnish
- Coming along....
- Status Check - 26 Aug 01
- Lumberdudes boat pics.
- Sailing Rig for 8' Pram
- Need help on better seam filler
- Flatbottom river dory
- Skiff not dory!!
- Steam Boxes
- Launched!
- Treat the inside of the hull or not?
- Pictures of my progress
- lindseed oil
- Thompson's Water Seal -- Beware!
- Bedding Compound / Caulk
- CPES question
- filling primer
- Deck to Cabin seam repair
- Transom laminating
- Need Help Identifying
- What Would You Pay?
- Yet another launching.
- windlass installation
- AMF Flying Fish centerboard
- White oak logs for free in Arkansas
- Acorn almost finished
- 1st boat project
- Info on best method to remove old varnish?
- Parts sources for '63 evenrude 75hp
- Wooden Boat Purchase
- Damaged Varnish Finish Repaire
- It Floats!!!!
- Attn: CLC Kayay Builders
- Cosmetic laminating of 17ft Cavalier
- Mahogany+Varnish
- Small Gaoline Inboards
- A Gray Seal on eBay...
- Boat tarps/covers-plastic--anything but BLUE.
- What do you think of my new (old) boat?
- Scarf Joints
- Oars for a Dark Harbor 17
- Boat building Schools
- "The Legacy" Photos
- I Gota Crow!/ Sea Fever Coming Out Party!
- stainless steel and corrosion
- St Lawrence River Skiff
- Rich Kolin's "HEIDI"
- Planking a Rangeley Boat
- Fairing the frame
- how to drill prop shaft on the keel?
- How to lay on an even coat of paint on canvas deck?
- Pine / Fir strip planking
- Restoring Daisy
- cradles, slings, or fancy bunks
- Hydraulic Trailer in Michigan
- Rozinante building methods and plans
- SF Bay Pelican - stern repair
- Single Handed Thread won't open
- Can't stop the leaks...
- Status Check - 3 Sept 01
- New Ply on hull: Screws and...?
- bronze and iron
- Boomless Mainsail
- Epoxy + Alcohol ??
- Expanding my trade
- paint cracking at seams
- Putty as a Boat Building Material
- Do I need to replace screws?
- Boat ID
- Mainsheet traveler placement?
- Oval Head vs. Flat Head Screws
- metal centerboards
- Batten-Seam Planking
- CPES (Again)
- What plywood to use
- How fill cracks in Fir Marine ply?
- fiberglass planks with epoxy, before or after ??
- Homebuilt Plywood
- Restoring a boat Father built
- Bottom Job
- Stain reccomendations
- Roue 20
- everything.. let us pray.
- king's cruiser project.. month 11
- Ring shank nail sizes?
- Trident plans needed
- Status check - 09 Sept '01
- Last wooden boat from the A.King yard - HK
- Painting prep work
- Nautolex for Decks
- What to do 1st, 2nd, 3rd etc.?
- new paint for older boat
- Photos of my project
- Oar Dimensions
- rudder installation
- Red Lead Primer ?
- What do you put on the foot of the mast?
- Source for white oak in So Cal
- Fillits and Fiberglass Tape
- It floats!!
- What size boat shed?
- Lug rig questions
- In Memoriam Ventilator Doradum
- Drifts
- Rounded Hull Curlew Sloop
- EEEEGAADZ So much EPOXY conjecture!!!!
- How to get water out of Foam cusions?
- A psychological question
- transom question
- WINTER STICK
- Carvel Seams for Seasonal Use?
- Safety Standards for Backyard Boatbuilders
- Advice on winter project
- Iain Oughtred's Ness Boat
- She's Wet Again!
- Detail Sanders
- small displacement 4-stroke gas engine
- Progress photos, update
- Northern White Cedar
- Status Check - 16 Sept '01
- post-building blues
- 1940's 14 ft Thompson row boat
- painting hull
- Adding pictures
- cold molding schooner
- eun mara research...
- Converting to Pop Up tiller
- New decking
- Grey Seal home pages
- Pitch between the frames?
- spar varnish
- Canoe pic
- Painting advice
- Dynel Deck
- Malabar II building progress..photos
- Thkxs to Cleek and others
- yet another ******/epoxy qestion
- Mast hardware, desperate.
- Homade detail sander
- please keep an eye out for an old chesapeake deadrise for me
- restoration of tug CRIS FOSS
- The (non-Herreshoff) BOUNTY
- Finally some photos of my Folkboat
- Bird's Mouth Joinery Bits
- dirty boat shots of a sexy boat
- Dynel, Epoxy and Paint Failure
- Sea Bird Yawl
- Status check - 23 Sept 01
- Outboard on dory transom??
- Pelican Sailboat
- Sanding avoidance techniques
- shearwater
- epoxy fillets on clinker ply dinghy
- Transmission ideas?
- Dynel advice needed, other than primers...
- Lobsterboat Questions
- Primer/paint and waterline info
- Lead Ballast Question
- dimensions of keel-how much lead weight needed
- Ballast Keel Alloys
- O.K...Serious Help Here!
- Herreshoff 12.5
- Another keel is laid...
- Okoume vs. other plywoods - question
- Invisible butt joints
- keel bolts in outer space
- Why not - Douglas Fir?
- Laminated Keelson?
- budgeting for renovation
- Silicon
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.